Para la parte trasera
material : Acero al cromo de alta resistencia a la tracción
El tamaño. : 420
*La rueda dentada impulsada es un producto consumible. Como regla general, compruebe las ruedas dentadas cada 1000 km más o menos. (Si las ruedas dentadas tienen dientes más estrechos, deben ser reemplazadas. La vida de los piñones y la cadena aumentará con la lubricación diaria).
*Número de piñones traseros T÷Número de piñones delanteros T=Razón de reducción Cuanto más alta es la razón de reducción, más importante es para la aceleración.
*El Z125 PRO no es compatible con el cohete propulsor (trasero) 25T.
*Si cambias la velocidad a otro número de bisagra que no sea el normal, la pantalla del velocímetro no será correcta. En este caso, use la unidad de conversión de pulso de velocidad (762-4030100).
*Dependiendo del vehículo, puede ser necesario reemplazar la placa guía o la unidad de conversión de velocidad. Para más detalles, por favor, consulte la tabla de solicitud.
For rear
Material: Chromoly high-tensile steel used
Size: 420
*The drive / driven sprocket is a consumable item.Check the sprockets every 1000km as a guide for general riding.(If the tip of the tooth has become thin, please replace it.The life of the sprocket and chain can be greatly improved by daily lubrication.)
*The number of rear sprockets T ÷ the number of front sprockets T = deceleration ratio The higher the value of this deceleration ratio, the more acceleration is emphasized, and the lower the value, the more maximum speed is emphasized.
*Z125 PRO is not compatible with 25T driven sprocket (rear).
*If you change the number of teeth to other than the stock number, the speedometer display will show an error.In this case, use the speed pulse conversion unit (762-4030100).
*Depending on the model of vehicle, the number of T's that cannot be installed or the guide plate may need to be replaced or a speed conversion pulse unit may need to be installed.Please refer to the compatibility chart for details.