calibre : φ22
El tono del carburador : Single Body
[Partes incluidas]
Aislante
Colector de extrusión de aluminio
Junta
[Se recomiendan piezas opcionales]
Tornillo de ajuste grande
Juego de tanque de captura de petróleo universal
[Se necesitan piezas adicionales para la instalación]
Juego de acelerador (para TM-MJN22/24/26) (igual que el cable del acelerador STD). )
Uno de los siguientes limpiadores de aire
Embudo original de Yoshimura para TM-MJN22/24/26
・DUAL STACK FUNNEL SYSTEM SET for TM-MJN24/TM-MJN26
Filtro de aire K&N (FILTRO DE POTENCIA)
*Dependiendo de las especificaciones de su coche, puede ser imposible mantener el espacio entre el motor y la parte inferior del carburador. .
*Al instalar este producto en un vehículo equipado con Cola de Monstruo (Ciclón Tipo 7), el silenciador y el carburador interferirán entre sí. Utiliza el espaciador de ángulo (se vende por separado) para cambiar el carburador de la alimentación derecha por el de la izquierda.
*Puede elegir entre los siguientes 2 tipos de productos de acuerdo con las especificaciones del motor. Los accesorios son los mismos, pero el escenario es diferente. .
*Este producto es una parte especial de las carreras.
Intake Diameter:φ22
Carburetor Pitch :Single Body
[Included parts]
・Insulator
・Machined Aluminum Manifold
・Gasket
[Separately recommended parts]
・Large Adjusting Screw
・Universal Oil Catch Tank Set
[Separately required parts for installation]
・Throttle Set (for TM-MJN22/24/26) (Must be installed with the same routing as stock throttle wire.)
Any of the following air cleaners
・Yoshimura original funnel for TM-MJN22/24/26
・DUAL STACK FUNNEL SYSTEM SET for TM-MJN24/TM-MJN26
・K&N air filter (POWER FILTER)
*Since the clearance between the lower part of the carburetor and the engine may not be secured depending on the specification of the vehicle, it is necessary to secure the clearance by adding angle spacers (sold separately)...
*If you install this product on a vehicle equipped with Cyclone Type 7 (MONSTER TAIL) for MONKEY, the exhaust and carburetor will interfere with each other.Use the angle spacer (sold separately) to change the right hand carburetor to a left hand one.
*You can choose from the following two types according to the specification of your engine.The accessories are the same, but the setting is different...
*This product is for racing use only.