*Este producto es aproximadamente 65mm más atrás y 3mm más bajo en altura que la manija de stock.
*La anchura total es de -5mm en el extremo de la palanca de stock.(Anchura total:±20mm/altura total:±40mm) No se requiere ningún cambio estructural.
*No es necesario cambiar el latiguillo/arnés/cable para este producto, pero si le preocupa, cambie el latiguillo de freno a la longitud adecuada. Por favor, ajuste la tensión del cable del eje debido al cambio de manejo.
*Hay un error en el grosor de la pintura de este producto. Al girar el lado del eje, puede estar embotado. En este caso, es necesario ajustar el lado del manguito del acelerador afeitando con una lima.
*Las marcas de perforación de este producto son sólo de referencia. Ajuste la posición del asa a su gusto.
*Existe el caso de que el agujero de la caja de interruptores de este producto esté ligeramente desalineado. En tal caso, puede ser necesario modificarlo ampliando el orificio. Si eres una persona quisquillosa con la instalación atornillada, o estás nervioso por el coste de la mano de obra y el proceso, te recomendamos que consultes con la tienda Honda Dream de antemano.
*Tenga en cuenta que las especificaciones del producto pueden estar sujetas a cambios debido a la conveniencia del fabricante. Por favor, entiéndelo.
[Size*] W: 710 H: 100 R: 200 L: 130
[Handle diameter] 1 inch (25.4mm)
*W (Overall width) H (Height) R (Amount of pullback) L (Clamp section straight) Unit (mm)
*This product is approximately 65mm back and 3mm lower in height than the stock handle.
*Overall width is -5mm at the end of the stock lever.(Full width: ±20mm / height: ±40mm) No structural changes are required.
*This product does not require any changes to the hoses / harnesses / wires, but if you are concerned, please change the brake hoses to an appropriate length.Adjust the tension of the axle wire due to the changes in handling.
*The thickness of the paint on this product may vary.There may be a dullness when turning to the axle side.In this case, it is necessary to adjust the throttle sleeve side of the handlebar by shaving with a file.
*The punch marks on this product are for reference only.Please adjust the position of the handlebar to your liking.
*The holes in the switch box of this product may be slightly out of alignment.In this case, it is necessary to widen the hole.If you are a person who is finicky about bolt-on installation, or if you are nervous about the labor cost and process, it is recommended that you consult with your HONDA Dream shop beforehand.
*There may be changes in product specifications due to the manufacturer's reasons.