calibre : Φ40
cuerpo base : TMR40-D21
El tono del carburador : 77-93-77
El diámetro de la espiga : 45mm
La longitud de la espiga : 30mm
[Se necesitan piezas adicionales para la instalación]
Necesitará uno de los siguientes juegos de porta-aceleradores.
Juego de soporte del acelerador Yoshimura Racing para el cuerpo grande TMR (L=950mm)
Juego de soporte del acelerador de carreras Yoshimura para el cuerpo grande del TMR con interruptor (L=950mm) (era necesario cambiar el cableado del acoplador del lado del interruptor)
[Se requieren partes extras]
Kit de tanque de respiración de aceite de Yoshimura
Bandas aislantes (40-60)
*La longitud del cable del acelerador es la configuración estándar. Tenga en cuenta que puede ser diferente dependiendo de la manipulación.
*La imagen es sólo de referencia.
*En caso de que el grifo de combustible entre en contacto con el depósito de combustible, puede evitar este problema sustituyéndolo por un grifo de combustible externo (no disponible para los coches con bomba de combustible).
Intake Diameter:Φ40
Base Body:TMR40-D21
Carburetor Pitch :77-93-77
Spigot Outer Diameter :45mm
Spigot Length :30mm
[Separately required parts for installation]
Either of the following throttle holder sets is required.
・Yoshimura Racing Throttle Holder Set for TMR Large Body (L=950mm)
・Yoshimura Racing Throttle Holder Set for TMR Large Body with Switch (L=950mm) (Switch side coupler wiring required to be changed)
[Parts required separately]
・Yoshimura Oil Breather Tank Kit
・Insulator Band (40-60)
*The length of the throttle wire is the standard setting.Please note that it may vary depending on the installation method.
*Images are for reference only.
*If the fuel cock interferes with the installation, it may be possible to avoid it by replacing the cock with an external cock such as Pingel (not available for vehicles with fuel pump).
* Please note in advance that cancellation and/or return of this product cannot be accepted once the order has been placed.