- First-class products are always better, but I thought that a measuring instrument of this price would be sufficient. It is more reliable than no management. There are many comparison videos on Youtube...Lee mas
- I am satisfied with the well made product, but I have old eyes and it is hard for me to see the memory.Otherwise, it is OK.Lee mas
- Not bad, but the lock part is sometimes subtle and difficult to use.Lee mas
- I can use it for daily maintenance without any problem. The price is reasonable. The long handle makes it easy to apply force and easy to use.Lee mas
- I bought this for Stem Nut and Wheel nut of my car.The Torque wrench is a fairly inexpensive part of the Torque wrench, but it is not excessive or inadequate.Lee mas
- This is used for areas where the Torque is Large. Measurement is also possible.Very easy to use.Lee mas
- I bought a Torque wrench because I didn't have one before.Recently, I had more and more chances to tighten the Rear Axle Nut for chain tension adjustment, etc. I did not know how tight I should tighte...Lee mas
- I am not sure if the Torque is accurate or not. I am a little worried about that because it is made in Taiwan...but there is one great advantage.It is bigger, heavier, and longer than other Torque wre...Lee mas
- I purchased this product to use when changing Tire.It was just the right length, and I personally liked it just fine.Lee mas
- I purchased this for Torque management of Axle Shaft installation.The wide range of the Torque measurement range could be used for Caliper Mounting Bolt.The most Large is 210 Nm, so it is indeed Large...Lee mas
- It is large and can be used for changing tires on cars. It is not suitable for engine work.Lee mas
- The content of the instruction manual of the attachment was difficult to understand, but I was able to understand it by the explanation written in the box. I think that the cost is good.Lee mas
- I always ignore Torque when I install Parts and I was worried about it.But for a cheap price, Case is solid.I thought that the time to use it would come sooner or later.Lee mas
- It is 28N-m, so less than 3kg, and Torque is the smallest value around here.Familiar ones are like Oil's Drain bolt.This area is OK, but delicate bolts such as Cylinder head cannot be managed.Because ...Lee mas
- Orthodox pre-set type, easy to use, up to 200N type, big and heavy, but well made. The only difference is the Torque value, Quantity:Set is a little difficult to get used to. Because the basic tick va...Lee mas
- Used for Z900rsChain adjustment, tightened at 110kn.Lee mas
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING