- Originally, there was a clattering feeling when starting and poor connection, but by replacing it with the company's Clutch Plates and adding this product at the same time, this phenomenon did not occ...Lee mas
- [How is it used?I bought it because I use Enduro as my main and use Clutch a lot for logs and gullies.Was the one you received as per Image?It is exactly as shown in the Image. I even feel that it is ...Lee mas
- Well, okay, for a good price. (It's a waste and a shame, even though the things are good.) The enclosed Bolt is cheap without hardening and may be looser than OEM Product.Lee mas
- Not only is it easier to raise the front end, but I can clearly feel when cutting and connecting the clutch at low speeds where the road conditions are bad or when there are bumps and gullies!The prin...Lee mas
- It is still at the breaking-in stage.Clutch is a Wire type and has been improved from a slippery Fee Ring to a spastic Fee Ring.Clutch lightness does not seem to have changed.It is now difficult to en...Lee mas
- The clutch connection used to be sluggish, but after replacing it with this one, the connection is now spasmodic, and it is easier to front up. It is the best for touring on forest roads.Lee mas
- Maybe I just don't have the skills, or maybe my expectations were too high, but I felt little effect.I understood how it works and installed it, so I don't think it is a bad thing.I'm tempted to try a...Lee mas
- Mounted on SEROW-250FinalI use it mainly on forest roads, TRIAL, and occasionally for commuting.Quantity of Washer:1 Set of 2pc. The pull is lighter than I expected, and I have a 2Finger Lever on it.T...Lee mas
- I put in 2 Washers each.I think that Clutch has become more disconnected and connected.The grip on the clutch lever also feels lighter.The brake pedal must be removed for installation.Since the length...Lee mas
- I used it on my Yamaha TY250S.Normal clutch inevitably feels slightly slippery andWhen I was thinking about what I could do about it, I found out about this product and bought it.The clutch spring was...Lee mas
- I use it on my YZ125X, and the main way I use it is as a Motocross. 125cc often requires a little bit of aggressive traction at a moment's notice, and that's when this Retainer by Kitamura shows its p...Lee mas
- [How is it used?While refreshing the Clutch-related Refresh of SEROW225, which has over 20,000km Judder all over the place.If you're going to remove ClutchCase anyway. So we purchased the Clutch Retai...Lee mas
- Spring was originally in good condition to sit on.I didn't feel much effect.I like that you can adjust the strength by adding Washer.Lee mas
- The slight lag when connecting Clutch is completely eliminated.I was completely skeptical about it because it was introduced on Net blogs and You Tube, but I bought it because I had a few extra Points...Lee mas
- The clutch on my XG250 TRICKER, which is a fast commuter train, is very loose and not well connected, so I put it to the test.The result is Large satisfaction. 2 Washers, not too tight, but not too ti...Lee mas
- Improved Clutch usabilityIt is now sputtering and snappy and connects well.The difference before and after the installation of this product can be felt very clearly and the effect is very large.Lee mas
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING